Nihon Kohden X076 9.6V 3800mAh Compatible New Replacement Battery for PVM-2700

Product Specification

Nihon Kohden X076 9.6V 3800mAh Compatible New Replacement Battery for PVM-2700 PVM-2703 PVM-2701 SB-201P

►Brief Description

If you are looking for a high-performance replacement battery for Nihon Kohden devices such as PVM-2700, PVM-2703, PVM-2701, SB-201P, this X076 9.6V 3800mAh compatible battery is your best choice.

►Why choose this battery?

1. Perfect compatibility, ready to use

Strictly comply with Nihon Kohden's original specifications, seamlessly adapt to PVM-2700 series and SB-201P devices, no complex debugging required, and the full performance of your device will be restored immediately after installation.

2.3800mAh large capacity, long battery life

Using high-quality lithium batteries with a capacity of up to 3800mAh, the operating time of your device can be greatly extended and the hassle of frequent charging can be reduced. It is especially suitable for scenarios that require long-term continuous work, such as ICUs and operating rooms.

3. Multiple safety protection, medical grade guarantee

The built-in smart chip supports overcharging, over-discharging, short circuit and overheating protection, complies with medical device safety standards, eliminates accidental interruptions caused by battery problems, and protects the safety of patients and medical staff.

4. Durability and stability, long cycle life

The battery cell structure is optimized to support more than 500 charge and discharge cycles, and the low self-discharge design allows it to maintain high power output even after long-term storage, meeting the needs of rapid response in emergency situations.

►Specification

►Battery Installation Steps

1.   1. Turn off the device

Make sure the medical device (such as PVM-2700 series or SB-201P) is turned off to avoid operating with power on.

2. Locate the battery compartment

Depending on the device model, find the battery compartment (usually on the back or bottom of the device, you may need to remove the outer shell or slide cover).

3. Remove the old battery (if applicable)

Disconnect the old battery interface and carefully remove the old battery. Pay attention to the interface direction (some models have a snap design).

3. Install a new battery

Align the new battery interface with the device slot (pay attention to the positive and negative directions) and gently insert it until the snap is fixed.

Make sure the battery is stable and not loose.

4. Restore the device

Reinstall the battery compartment cover or outer shell and tighten the screws (if any).

If you are interested in Nihon Kohden X076 9.6V 3800mAh Compatible New Replacement Battery for PVM-2700 PVM-2703 PVM-2701 SB-201P, please let me know, looking forward to your early inquiry.