Submerged Installation Titanium Solution Ground PH Sensor For Sewage Water

Product Specification

Submerged Installation Titanium Solution Ground PH Sensor For Sewage Water

During measurement or when the electrode is not used for a short time, the electrode needs to be stored in a container filled with electrolyte (eg: 3mol/L KCl) or buffer pH4 or pH7. Confirm that the electrolyte level in the container is lower than the filling level in the electrode.

Specification:

Please click the catalog of pH controller here:

Daruifuno Catalog.pdf

Brief introduction:

◆ pH composite electrode, metal alloy titanium solution grounding electrode, strong corrosion resistance environment, used for accurate detection in severely polluted environments.
◆ Built-in high-precision NTC10K temperature resistance
◆ The body adopts high-performance PPS plastic shell encapsulation
◆ The electrode is equipped with a protective cover with its own cleaning interface
◆ Blue low-impedance hemispherical glass head
◆ Point-shaped ceramic hole sand core reference, the reference electrode is Ag/AgCl, the reference is filled with saturated KCL+excess KCL crystal, and the service life is long.
◆ The reference system is a double salt bridge design

Aplication:

Water treatment monitoring

Drinking water,surface water,water quality analyze,ground water,ect.

Industrial process monitoring and dosing control

Chemical,petroleum,paper,food and medicine,PCB manufacturing,etc.

FAQ

1. What is themeasurement principle of this pH electrode?
A: The pH value potentiometric method uses the potential difference of glass electrodes for pH measurement.

2. How is this glass pH electrode composed?
A: The pH electrode is usually composed of an indicator electrode and a reference electrode.

3. How to judge the pH of the solution?
A: If the internal hydrogen ion concentration of the pH glass bulb is lower than the outside, the measured solution is recorded as acidic and the pH value is lower than 7; if the two are the same, the solution is neutral and the pH value is equal to 7; if the internal hydrogen ion concentration is higher than externally, the measured solution is alkaline and the pH value is higher than 7.

4. What is the wire length of the pH electrode?
A: The lead wire of this electrode is 5m by default, other lengths need to be customized, contact our customer service, the price will vary with the change of length.

5. How often must the pH sensor be calibrated?
A: Depends on the type of sample:
Dirty samples and non-aqueous samples require more frequent calibration.
Depends on the required accuracy:
For very accurate measurements, at least daily calibration is required.
Depends on the quality of the electrode:
Old electrodes require more frequent calibration.